NF L24-985-1998 航空航天系列.耐蚀钢FE-PA3004制螺旋形自锁螺纹螺套

上一篇: NF L24-982-1998 航空航天系列.螺旋形自锁螺纹螺套.组装程序
下一篇: NF L24-984-1998 航空航天系列.耐热镊基合金NI-PH2801(INCONELX750)制镀银螺旋形自锁螺纹螺套

Product Code:SAE J1453
Title:Fitting--O-Ring Face Seal
Issuing Committee:Hydraulic Tube Fittings Committee
Scope:This SAE Standard covers material, dimensional, and performance requirements of steel O-ring face seal fittings for tubing and the O-ring face seal interface and nut portion of hose stem assemblies for nominal tube or hose diameters 6.35 mm (0.250 in) through 38.1 mm (1.500 in). These fittings are intended for general application and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures. These fittings are capable of providing leak-proof full flow connections in hydraulic systems operating from 95 kPa (28 in Hg) vacuum to working pressures shown in Table 1. Since many factors influence the pressure at which a hydraulic system will or will not perform satisfactorily, these values should not be construed as guaranteed minimums. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to assure that required performance levels will be safe. See Figure 1.The rated working pressure of a fluid conductor assembly using SAE J1453 hose stem connections or formed tube connection per Figure 32a, shall not exceed rated working pressure of the lowest rated component thereof.Product Code:SAE J1095
Title:Spoke Wheels and Hub Fatigue Test Procedures
Issuing Committee:Truck And Bus Wheel Committee
Scope:This SAE Recommended Practice provides uniform laboratory procedures for fatigue testing of spoke wheels and hubs intended for normal highway use on trucks, buses, truck trailers, and multipurpose passenger vehicles. The hubs included have bolt circle diameters from 165.1 to 335.0 mm (6.50 to 13.19 in). It is up to each hum and/or spoke wheel developer to determine what test method, accelerated load factor and cycle life reuirements are applicable to obtain satisfactory service life in a given application. When deviations from the procedures recommended herein are made, it is the responsibility of th ehub and/or spoke wheel developer to modify other parameters to obtain parameters to obtainsatisfactory service life.